I gave the original Scura 120 away to a friend, but I decided to make a new one for myself. I wasn’t going to, but I wanted to make 2 ‘bags’ of bits to post to friends so they could build their own. I thought, well, if I am printing two sets, I might as well make three. So I did.
I even added a rudimentary viewfinder this time. It turned out to be pretty much useless, so I barely used it.


It was much easier this time as I was ‘experienced’. I still could not fit the tiny nuts in all the right places, but it was fine. Once I had finished, I loaded it with a roll of Kentmere 100 and took it for a wander in the woods.
Here are all the results.












These were taken on two different outings. During the first, part of the foam I used as a light shield bunched up under the winder and pushed off the clip. That made it loose and almost drop off. Luckily, I saw it in time and put the whole thing in my camera bag, keeping it light-tight. Once home, I put it in a dark bag and removed the film so I could fix it. Then I reloaded the film to the last shot taken and took it out near Hampole, Richard Rolle’s home. Both were lovely walks, full of autumn colours, though you can’t tell from these. My friend and I decided to be ghosts on one shot but ended up chatting too much, but that is a good thing, really.
Oh, and this time all the parts printed perfectly, no ghosts in the machine. 🙂